RF Analyzer

Introduction

Clicking the RF Analyzer tab sets the Test Set to analyzer mode and displays the associated parameters in the Settings panel. In Analyzer mode the Test Set can act as a simple tuned receiver and make frequency and power level measurements. However, with the Bluetooth demodulator enabled, you can make more complex measurements on a Bluetooth modulated signal without establishing a link with the transmitting EUT.

RF Analyzer Tests

With Demodulator set to CW

With Demodulator set to Bluetooth 1.X

The following Bluetooth 1.x transmitter measurements use measurement algorithms that are in full compliance with the Bluetooth RF Test Specification.

With Demodulator set to Bluetooth 2.0

The following Bluetooth 2.0 transmitter measurements use measurement algorithms that are in full compliance with the Bluetooth RF Test Specification.

RF Analyzer Settings

The following settings are available: