Test Set Beeper
Last updated: May 24, 2006
Description
This parameter allows you to change the beeper state to on or off. A beep will indicate error conditions caused during manual or remote operation of the test set.
A 100 ms, 1.24 kHz audible tone (beep) is generated when an error message is logged and the beeper state is set to on. If two errors are generated in quick succession, two beeps are generated to indicate that more than one error has been logged.
The beeper state can be manually set in the Instrument Setup window found in the SYSTEM CONFIG screen.
Example
OUTPUT 714;"SYSTEM:BEEPER:STATE OFF"
|
top
of page