How Do I Change Access Parameters?
Last updated: January 3, 2008
General Procedure
A. Select the Access Parameters Menu.
-
Press the
CALL SETUP
key.
-
Press the left
More
key, go to
Call Control 2 of 2
(in the Test Application) or
Call Control 2 of 3
(in the Lab Application).
-
Select
Access Network Info
(
F2
), go to AN Info menu.
-
All access parameters are available by pressing the
F4
on
AN Info
menu. Depending upon the current setting of the Access Channel MAC Subtype, the
F4
is labeled as either
Access Parameters
or
Enhanced Access Parameters
.
-
Select
F4
. A typical display for the Access Parameters menu or the Enhanced Access Parameters menu is shown as below.
B. Set an Access Parameter.
-
Turn the knob to highlight a parameter and then press the knob.
-
Enter a value or selection and press the knob.
-
Select
Close Menu
(
F6
).
To Configure the Test Set to Default Access Channel MAC Subtype
To configure the test set to Default Access Channel MAC Subtype,
-
set the
Protocol Rel
(
F11
on Call Parms 2 of 3) to
0 (1xEV-DO)
, or
-
set the
Protocol Rel
(
F11
on Call Parms 2 of 3) to
A (1xEV-DO-A)
and set the
Release A Physical Layer Subtype
to
Subtype 0
from the
Protocol Subtype Configuration
menu by pressing the
F12
(
Protocol Subtype Config
).
-
set the
Protocol Rel
(
F11
) to
A (1xEV-DO-A)
, set the
Release A Physical Layer Subtype
to
Subtype 2
and
PL Subtype 2 Access Channel MAC Subtype
to
Default
from the
Protocol Subtype Configuration
menu by pressing the
F12
(
Protocol Subtype Config
).
To Configure the Test Set to Enhanced Access Channel MAC Subtype
To configure the test set to Enhanced Access Channel MAC Subtype, set the
Protocol Rel
(
F11
) to
A (1xEV-DO-A)
, set the
Release A Physical Layer Subtype
to
Subtype 2
and
PL Subtype 2 Access Channel MAC Subtype
to
Enhanced
from the
Protocol Subtype Configuration
menu by pressing the
F12
(
Protocol Subtype Config
).
|
top
of page