How Do I Change Configurable Attribute Control Mode?

Last updated: July 22, 2008

A. Select the Configurable Attribute Control Menu.

Press the CALL SETUP key.
Press the left More key, go toCall Control 2 of 2 (in the Test Application) orCall Control 2 of 3 (in the Lab Application).
SelectAccess Network Info ( F2 ).
SelectConfigurable Attribute Parms ( F1 ).
The parameters under Configurable Attribute Control menu are different depending upon the current physical layer subtype.
- When the test set is configured to subtype 0 physical layer (see To Configure the Test Set to Subtype 0 Physical Layer for detailed procedure), a typical display for Configurable Attribute Control menu is shown as below.
- When the test set is configured to subtype 2 or subtype 3 physical layer (see To Configure the Test Set to Subtype 2 Physical Layer and To Configure the Test Set to Subtype 3 Physical Layer for detailed procedure), a typical display for Configurable Attribute Control menu is shown as below.

B. Set the Control Mode for a Configurable Attribute.

IMPORTANT

You can not change the session negotiation control mode for a configurable attribute when a session is open and Call Limit Mode is on (because the test set would not be able to establish a traffic connection to re-negotiate the value when call limit mode is on).

Turn the knob to highlight a parameter and then press the knob.
Enter a value or selection and press the knob.
Select Close Menu ( F6 ).

How Do I Change Configurable Attribute Control Mode?

A. Select the Configurable Attribute Control Menu.

B. Set the Control Mode for a Configurable Attribute.

Related Topics