How Do I Configure Test Signals in CW Operating Mode?

Last updated: May 24, 2006

1. Press the CALL SETUP key.
2. Press the Operating Mode ( F1 ) key and set the operating mode to CW .
3. Press the Test Signal ( F9 ) key to select a signal for output to the front panel RF connector currently selected. See Front Panel Connectors to select either RF IN/OUT or RF OUT ONLY connector.
4. Select a test signal from the menu and confirm the selection by selecting Yes in the dialog box.
      

   NOTE

   Changing test signal requires several seconds to complete.

   ---

      

5. Press the Cell Power ( F7 ) key and set the signal output power level to meet your testing needs.
6. Press the RF Gen Freq ( F8 ) key and set the signal output center frequency to meet your testing needs.
7. Press the Receiver Control ( F12 ) key and manually set the test set's receiver control parameters (such as expected CW power, measurement receiver frequency, and reverse link receiver frequency) to the desired values (see Manual Receiver Control in CW Operating Mode ).