How Do I Change Generator Information?

A. Select the Generator Info Menu.

1. Press the CALL SETUP key.
2. Press the left More key, go to Call Control 2 of 2 (in the Test Application) or Call Control 2 of 3 (in the Lab Application).
3. Select Generator Info ( F3 ) go to Gen Info menu.
4. Depending upon the current physical layer subtype, the Generator Info menu provides different parameters for your access.
   • When the test set is configured to subtype 0 physical layer (see To Configure the Test Set to Subtype 0 Physical Layer for detailed procedure), a typical display for Gen Info menu is shown as below.
     
   • When the test set is configured to subtype 2 physical layer (see To Configure the Test Set to Subtype 2 Physical Layer for detailed procedure), a typical display for Gen Info menu is shown as below.
     

B. Set parameters on Gen Info menu.

1. Select any Gen Info softkey ( F1 to F5 ) to select a parameter.
2. Change the parameter as needed using the knob and/or keypad.

Related Topics

Cell Power, AWGN (Additive White Gaussian Noise) Power and Total RF Power

External Trigger Type

PN Offset

Termination Parameters

Code Channel Parameters