How Do I Configure the Test Set for My Test System?
Last updated: May 24, 2006
A. Configure instrument information and setup.
-
Press the
SYSTEM CONFIG
key.
-
Press the
Instrument Setup
(F1) key.
-
Adjust an instrument setting.
-
Press the
Close Menu
(F6) key.
Always verify that the test set is responding to a new LAN IP Address by pinging the test set. If the test set does not respond to the ping, cycle power. This will ensure that the test set will respond to the new LAN IP Address.
B. Set amplitude offsets.
-
On the
Configuration Summary
screen (not shown), press the
RF IN/OUT Amptd Offset
(
F5
) key.
-
On the RF IN/OUT Amplitude Offset screen, press the
RF IN/OUT Amptd Offset Setup
(
F2
) key.
-
Enter the amplitude offset for the test frequencies you use.
-
Press the
Close Menu
(
F6
) key.
C. Check message log.
-
From any System Config screen, press the Message Log (
F7
) key and view the message log.
-
Press the
Return
(
F12
) key.
|
top
of page