Call Processing
Data Channel
Configuration
Yes No Did not apply
Please provide additional comments about this page. (Optional, 255 character max) Email address (optional):
Last updated: May 24, 2006
Probe num step sets the number of steps (access probes) in a single access probe sequence.
Probe num step is sent in the Access Parameters message (see TAP/ETAP Data Connection Call Flow ).
Probe num step can be changed at any time and will be sent out in the next overhead message.
GPIB Command: CALL[:CELL]:APARameter:PROBe:STEP:COUNt
Manual Operation: How Do I Change Access Parameters?
top of page
top
of page