CALL:CLPControl

Last updated: May 24, 2006

CALL[:CELL[1]]:CLPControl:REVerse:MODE<[:SELected]|:TA856>

Function

Sets/queries the reverse closed loop power control mode. See Reverse Closed Loop Power Control .

NOTE

In a fast switching application (such as E1985E), the :SELect, :TA856 and :TA2000 format mnemonics access the same shared setting value. It is recommended to use the CALL:CLPControl:REVerse:MODE (without any format mnemonic) to set the reverse closed loop power control mode.

Requirements

Test Application Revision: A.01.20 and above
Lab Application Revision: A.01 and above

Setting

Range: ACTive|ALTernating|DOWN|UP
(ACTive is not available in IS-856 Test Operating Mode .)

Query

Range: ACT|ALT|DOWN|UP
(ACT is not available in IS-856 Test Operating Mode .)

*RST Setting

ACT

Programming Example

 
OUTPUT 714;"CALL:CLPControl:REVerse:MODE ALT" 
! Sets the closed loop power control mode to alternating up/down bits.

CALL[:CELL[1]]:CLPControl:REVerse:PCSTep

Function	Sets/queries the reverse closed loop power control step size. See Power Control Step . This is a "Configurable Attribute" that is set during session negotiation. Its value can not be changed while call limit mode is on (see Call Limit Mode ).
Requirements	Test Application Revision: A.01.20 and above Lab Application Revision: A.01 and above
Setting	Range: DB1: 1 dB DBHalf: 0.5 dB
Query	Range: DB1\|DBH
*RST Setting	DB1
Programming Example OUTPUT 714;"CALL:CLPControl:REVerse:PCSTep DBHalf" ! Sets the closed loop power control step size to 0.5 dB.