|
|
Manual Operation
Last updated: May 21, 2009
This page provides links to information on using the test set from the front panel including:
Data Connection Operations
(procedures for opening/closing a session/test data connection and performing handoffs),
Access Network Emulator Configuration
(procedures to configure the specific parameters for the test set's base station emulator),
Multi-unit Operations
(how to synchronize multiple test sets for particular test case such as hybrid mode),
Making Measurements
(general procedures to use the measurements, and step by step procedures for performing Individual 3GPP C.S0033 tests),
Data Channel (Lab Application Only)
(DPA based packet data operations),
Protocol Logging (Lab Application Only)
,
Test Set Configuration
(such as amplitude offsets, GPIB and LAN ports),
General Manual Operation
(such as Help Mode, which provides context-sensitive GPIB command syntax assistance, and Save and Recall Registers, which provide a way to return to frequently used setups).
If you have trouble finding the information you need below, use the search field at the top of this page to search the contents of this guide
Data Connection Operations
Access Network Emulator Configuration
-
How Do I Change Call Parameters?
(including Protocol Release, Physical Layer Subtype, Session Application Type, ACK Channel Bit Fixed Mode Attribute, DRC Value Fixed Mode Attribute, Application, AT Directed Packets, Cell Band, Channel, FTAP rate, limited TAP...)
-
How Do I Change Configurable Attribute Control Mode?
(PCCC Control, Rate 1M8 Supported Control)
-
How Do I Change Cell Parameters?
(Color Code, Control Channel Data Rate, Sector ID, Pilot Drop...)
-
How Do I Change Channel Gain/Traffic Info Parameters?
(T2P Power Parameters, Enhanced Traffic Parameters, ACK Channel Gain, Data Offset Nom, RRI Gain Parameters...)
-
How Do I Change Access Parameters?
(Open Loop Adjust, Probe Initial Adjust, Probe Num Step...)
-
How Do I Change CDMA System Time Parameters?
-
How Do I Change Generator Information?
(AWGN power, PN offset, H-ARQ/L-ARQ Channel Level, RPC Channel Level, ACK R-Data After...)
-
How Do I Change Parameters in IS-856 Test Operating Mode?
Data Channel (
Lab Application Only
)
Protocol Logging (
Lab Application Only
)
|
|
Click here for step-by-step instructions for performing individual C.S0033 tests.
top
of page