Step 3: Set Measurement Parameters

Last updated: April 14, 2005

In this step you set up the measurement parameters which are fixed throughout testing, such as measurement timeouts and trigger arm. It is recommended that you set all measurements to single trigger (see Trigger Arm (Single or Continuous) Description ).

Click on the "More Details on this Step" icon below for additional information on this step.

You set up other less general measurement parameters while performing specific C.S0033 tests as discussed in Step 5: INITiate and FETCh Measurements .

An excerpt from the comprehensive example program is shown below:

 
1030 !**************************************************************************
1040 ! STEP 3: SET MEASUREMENT PARAMETERS
1050 !**************************************************************************

2780       OUTPUT Testset;"SETUP:CONTINUOUS:OFF"
2790       ! Set all measurements to single trigger

5110       OUTPUT Testset;"SETUP:DOWQ:TIMEOUT 10"
5120       ! Set waveform quality measurement timeout to 10 seconds

5910       OUTPUT Testset;"SETUP:DAPOWER:TIMEOUT 1"
5920       ! Set DIGITAL Power timeout to 1 sec
5930       OUTPUT Testset;"SETUP:CTXS:TIMEOUT 5"
5940       ! Set TX Spur Emissions timeout to 5 sec

7140       OUTPUT Testset;"SETUP:CPOWER:TIMEOUT .5"
7150       ! Set Channel Power timeout to 0.5 sec

8060       OUTPUT Testset;"SETUP:CAPP:TIMEOUT 10"
8070       ! Set access probe power timeout to 10 seconds

9090       OUTPUT Testset;"SETUP:TROP:TIMEOUT 5"
9100       ! Set TROLPC measurement timeout to 5 s

10060       OUTPUT Testset;"SETUP:CPERROR:TIMEOUT 10"
10070       ! Set PER measurement timeout to 10 s

Navigation