Packet Data Connection Call Flow

Last updated: May 24, 2006

This section is only applicable to the lab application.

The following diagrams illustrate the key steps and messaging to establish a packet data connection between the access terminal (AT) and the test set when the test set is configured to use the Default Packet Application (DPA) (see Session Application Type ).

For the key steps and messaging to establish a test data connection (TAP/ETAP), see TAP/ETAP Data Connection Call Flow

• AT Initiated Packet Data Connection from Idle State
• AT Initiated Connection Close to Dormant State
• AN Initiated Connection Close to Dormant State
• AT Initiated Packet Data Connection Re-activation from Dormant State
• AN Initiated Packet Data Connection Re-activation from Dormant State

AT Initiated Packet Data Connection from Idle State

AT Initiated Connection Close to Dormant State

AN Initiated Connection Close to Dormant State

AT Initiated Packet Data Connection Re-activation from Dormant State

AN Initiated Packet Data Connection Re-activation from Dormant State