Reverse Mappings View

Last updated: July 23, 2008

This section is only applicable to the lab application.

An example reverse IP FLow Mappings view is shown below:

• IP KK

  IP KK is the ReservationLabel KK which is initiated by the AT and is used to apply additional IP Flows via negotiation of attributes ReservationKKQOSRequestFwd and ReservationKKQOSRequestRev.

• State

  This area shows the status of the individual Forward IP FLow. There are three states:

  • Not Configured: There is no associated KK Value for this flow and the packet filter count for this IP Flow is zero. Or there is an associated KK value for this flow due to a non-zero packet count, but there is no associated KK reservation. When the status is Not Configured, the test set will show blank on the screen.
  • Open: There is a reservation for the associated KK value for this flow, the IP Flow state for the associated KK is open.
  • Close: There is a reservation for the associated KK value for this flow. The IP Flow state for the associated KK is close.

  The State display is also controlled by MFPA Reservation Idle State / EMPA Reservation Idle State .

• MFPA Profile ID / EMPA Profile ID
• Priority

  The priority of IP FLow is sent to the AN in the AttributeUpdateRequest message.

• RLP NN

  This area shows the RLP FLow that the IP Flow mapped to.

• Config Rule

  This area shows the IP Configuration Rule which the IP FLow used.

• RTC MAC NN

  This area shows the RTC MAC Flow that the RLP FLow mapped to.