Call Processing

Last updated: April 20, 2009

This page provides links to descriptions of the numerous settings and operations available in the test set for base station emulation and call processing including: Test Set Operating Modes , Base Station Emulator Configurations , Call Processing Operation and General Information .

If you have trouble finding the information you need below, use the search field at the top of this page to search the contents of this guide. If you are new to using the test set, it may be helpful to review the Getting Started with Call Processing page.

Test Set Operating Modes

Base Station Emulator Configurations

Selecting an Operating Mode
Selecting a Cellular System Type
Setting Call Parms: Cell Band , RF Channel Number , Protocol Revisions , Radio Configuration , Service Option , Call Limit Mode , Call Drop Timer , Traffic Data Rate , Voice SO Mode
- only for Lab Application : R-FCH Gating , F-FCH Frame Pattern Setup , Calling Party Number Parameters
Setting Reverse Closed Loop Power Control (Rvs Power Ctrl, Rvs Power Ctrl Transient Parm, etc.)
Setting Control Channel Parameters (BCCH/CCCH Data Rate, Paging Data Rate, etc.)
Setting Cell Parameters (SID, NID, MCC, MNC, Paging Data Rate, etc.)
Setting CDMA System Time Parameters (Date, Time, Leap Seconds, Local Time Offset, etc.)
Setting Access Parameters (Power Step, Number of Steps, Maximum Request Sequence, etc.)
Setting Enhanced Access Parameters (Power Step, Number of Steps, Maximum Request Sequence, etc.)
Setting Registration Parameters (Timer Based Registration State, Power Up Registration State, etc.)
Paging IMSI Setup (Paging MSIN, MCC, MNC, Status Request Query State, etc.)
Setting Hard Handoff Parameters
Setting External Trigger
Configuring Cell Power and AWGN Power Levels
Configuring Forward Channel Power Levels and Walsh Codes (Code Channel Levels, Walsh Code, etc.)
Configuring the TDSO Supplemental Channel Information (Data Rate, Data Source, Encoder Type, etc.)
Setting Authentication Parameters (A-Key, RAND, RANDU, RANDSSD, etc.)
Real-Time Vocoder
MEID / Enhanced PLCM
Tx Timing Advance

Call Processing Operation

Establishing an Active Link with the Mobile Station
Performing a Registration
Performing a Hard Handoff
Performing Soft/Softer Handoffs ( Lab Application Only )
Performing Multi-Unit Synchronization ( applicable to the lab application and to a test application with the required feature license )
Short Message Service/ Multimedia Service ( applicable to the lab application and to a test application with the required feature license )
Paging Channel MER Description ( Lab Application Only )
Forward Power Control ( Lab Application Only )
Hybrid Mode ( Lap Application Only )
Performing Authentications ( applicable to the lab application and to a test application with the required feature license )
Call Waiting ( Lab Application Only )
FM Broadcast
Single channel GPS source ( applicable to the lab application and to a test application with the required feature license )
Assisted GPS (A-GPS) ( Lab Application Only )
Set CDMA System Time on Trigger ( Lab Application Only )

General Information

Mobile Reported Information
Forward Link Overview
Receiver Control
Expected Power
Settable Fields in Overhead Messages
Digital Bus Information ( applicable to the lab application and to a test application with the required feature license with rear panel digital bus only )