Operating Mode( F1 ) key and set the operating mode to
Test Signal( F9 ) key to select a signal for output to the front panel RF connector currently selected. See Front Panel Connectors to select either RF IN/OUT or RF OUT ONLY connector.
Changing test signal requires several seconds to complete.
Cell Power( F7 ) key and set the signal output power level to meet your testing needs.
RF Gen Freq( F8 ) key and set the signal output center frequency to meet your testing needs.
Receiver Control( F12 ) key and manually set the test set's receiver control parameters (such as expected CW power, measurement receiver frequency, and reverse link receiver frequency) to the desired values (see Manual Receiver Control in CW Operating Mode ).