How Do I Change F-FCH/Traffic Channel Parameters?

Last updated: June 12, 2007

The forward fundamental/traffic channel parameters are spread under several menus on test set's front panel.

Setting F-FCH/Traffic Levels and Walsh Codes

To set the F-FCH/Traffic level and walsh code parameters, see How Do I Change Generator Information?

Setting F-FCH/Traffic Data Rate, Voice SO Mode, Echo Delay parameters

To access the Traffic Data Rate, Voice SO Mode, Echo Delay parameters:

1. Press the CALL SETUP key.
2. Press the More key on the right side to display 2 of 4 menu.
3. Press the Traffic Data Rate ( F12 ) to select a value for the channel data rate.
4. Press the More key again to display 3 of 4 menu.
5. Press the Voice SO Mode ( F11 ) to select an audio source. Note this setting is applied only when a voice service option (SO1, SO3, SO17, SO68, or SO32768) is currently selected.
6. Press Echo Delay ( F12 ) to set the echo delay time. Note this setting is useful only when Voice Echo is currently selected in step 5.