Performing Specific Measurements and TIA/EIA-98-E Tests Manually

Last updated: September 2, 2009

• Measuring Access Probe Power
  • Testing 4.4.1 Range of Open Loop Output Power
  • Testing 4.4.3 Access Probe Output Power
• Measuring Channel Power
  • Testing 4.4.6 Minimum Controlled Output Power
• Measuring Code Channel Time/Phase Error
  • Testing 4.3.2 Reverse Pilot Channel to Code Channel Time Tolerance
  • Testing 4.3.3 Reverse Pilot Channel to Code Channel Phase Tolerance
• Measuring Digital Average Power
  • Testing 4.4.5 Maximum RF Output Power
• Measuring DTMF
  • Testing 10.1 Dual Tone Multifrequency (DTMF) Signaling
• Measuring Frame Error Rate (FER)
  • Testing 3.4.1 Demodulation of Forward Traffic Channel in AWGN
  • Testing 3.5.1 Receiver Sensitivity and Dynamic Range
• Measuring Gated Power
  • Testing 4.4.7 Standby Output Power and Gated Output Power
• Measuring Handoff Waveform Quality
• Measuring Maximum/Minimum Power
  • Testing 4.4.5 Maximum RF Output Power and 4.4.6 Minimum Controlled Output Power
• Measuring a Multi-tone Digital Audio
  • General Procedure for Downlink Measurement
  • General Procedure for Uplink Measurement
• Measuring Perceptual Evaluation of Speech Quality (PESQ) ( Only applicable to the feature-licensed lab application or test application )
• Measuring SINAD Sensitivity (for AMPS test per TIA/EIA-690 standard)
• Measuring Signaling Tone
  • Testing 3.3.5 Signaling Tone
• Measuring TDSO (Test Data Service Option) Frame Error Rate (FER)
  • Testing 3.4.1 Demodulation of Forward Traffic Channel in AWGN
• Measuring Time Response of Open Loop Power Control (TROLPC)
  • Testing 4.4.2 Time Response of Open Loop Power Control
• Measuring TX Dynamic Power
• Measuring TX Spurious Emissions
  • Testing 4.5.1 Conducted Spurious Emissions
• Measuring Waveform Quality/Code Domain Power
  • Testing 4.1 Frequency Accuracy
  • Testing 4.3.1 Time Reference
  • Testing 4.3.4 Waveform Quality and Frequency Accuracy
  • Testing 4.3.5 Code Domain Power
  • Testing 4.4.9 Code Channel to Reverse Pilot Output Power Accuracy
• Measuring Wideband Data Deviation
  • Testing 3.3.3 Wideband Data
• Example Usage of Reverse CLPC Transient Mode
  • Testing 4.4.4 Range of Closed Loop Power Control
• Measuring Paging Channel Message Error Rate (MER) ( Lab Application Only )
  • Testing 3.3.2 Demodulation of Slotted Mode Paging Channel
• How Do I Perform a Graphical Access Probe Power Measurement? (Lab Application only)
• How Do I Use R-FCH Gating for Talk Time Testing? (Lab Application only)