Programming

Last updated: September 2, 2009

The test set is programmable through the GPIB (General Purpose Interface Bus) located on the rear panel. This page provides links to documentation to help you program the test set including: Programming Guide and Comprehensive Example , Programming Examples for Individual Measurements and General Programming (including test system synchronization).

Programming Guide and Comprehensive Example

Programming: Getting Started Guide for cdma2000 Mobile Test : This guide provides a general approach to setting up a connection and obtaining measurement results programmatically. It gives an overview of how to configure the test set's base station emulator, perform key call processing operations, and perform measurements. The guide is built around a complete control program for testing a wireless device in a manufacturing environment. To download this complete control program, click here:
Control Program Example

Programming Examples for Individual Measurements

Programming an Access Probe Power Measurement
Programming an Analog Transmit Power Measurement (only for AMPS test)
Audio Analyzer Measurements
- Programming an Audio Frequency Measurement
- Programming an Audio Level Measurement
- Programming a Distortion Measurement
- Programming an SINAD Measurement
Programming a Channel Power Measurement
Programming a Code Channel Time/Phase Measurement
Programming a Digital Average Power Measurement
Programming a DTMF Measurement (only for AMPS test)
Programming a Fast Device Tune Measurement ( Only applicable to the lab application or feature-licensed test application )
Programming an FER (Frame Error Rate) Measurement
Programming a Frequency Modulation (FM) Measurement (only for AMPS test)
Programming a Frequency Stability Measurement
Programming a Gated Power Measurement
Programming a Graphical Access Probe Power Measurement (Lab Application only)
Programming a Handoff Waveform Quality Measurement
Programming a Maximum/Minimum Power Measurement
Programming a Multi-Tone Audio Measurement
Programming Paging Channel MER (Lab Application only)
Programming a Perceptual Evaluation of Speech Quality Measurement ( Only applicable to the feature-licensed lab application or test application )
Programming a Signaling Tone Measurement (only for AMPS test)
Programming the Spectrum Monitor
Programming a Swept Audio Measurement
Programming a TDSO Frame Error Rate Measurement
Programming a TROLP Measurement
Programming a TX Dynamic Power Measurement
Programming a Tx Spurious Emissions Measurement
Programming a Waveform Quality/Code Domain Measurement
Programming a Wideband Data Deviation Measurement (only for AMPS test)