Frequency Stability Measurement Troubleshooting

IMPORTANT

If the Access Probe Power measurement is currently selected and the Trigger Arm setting is Continuous, all other measurements are disabled. Use the SETup:CAPPower:CONTinuous command to set the trigger arm state to single and retry this measurement.

During remote operation of this measurement, you should configure the Trigger Arm to Single. See SETup:FSTability:CONTinuous . If single triggering is used during manual operation, press the START SINGLE key to trigger each measurement.

This measurement is not designed to measure digital signals.

See Input Signal Requirements .

Interpreting Integrity Indicator values

See Integrity Indicator .

Related Topics

Frequency Stability Measurement Description