Description
BASEBAND I/O
Four pins are functional on this connector:
-
I channel
-
Q channel
-
Ground
-
Ground
CLK IN
Not functional for this release.
COUNTER IN
Not functional for this release.
DATA IN
Not functional for this release.
DATA VALID IN
Not functional for this release.
ETHERNET TO FRONT PANEL
This RJ-45 connector is used with a separate LAN jumper cable to connect the front panel DATA connector to the rear panel LAN PORT.
The the DATA connector on the front panel is connected internally to the ETHERNET TO FRONT PANEL connector on the rear panel. In order to use the front panel DATA connector the user must connect the rear panel LAN PORT, to the rear panel ETHERNET TO FRONT PANEL connector with the LAN jumper cable.
The LAN jumper cable, part number E5515-61160, is supplied with the test set.
EXT INTERFACE CONTROL
Not functional for this release.
EXT SIG GEN/FRAME SYNCH
Not functional for this release.
FM MOD IN
This BNC connector allows you to use an external signal to frequency modulate the test set's RF generator. It has a fixed sensitivity of 20 KHz/volt, and a frequency range of 100Hz to 20 KHz.
GPIB
This GPIB connector allows test set control with compatible devices.
LAN PORT
This RJ-45 connector provides connection for downloading firmware upgrades, or new test applications into the test set. No other types of communication are possible with the LAN port.
PRINTER
Not functional for this release.
SERIAL 1
Not functional for this release.
SERIAL 2
Not functional for this release.
SERIAL 3
Not functional for this release.
TEST SET SYNCH IN
Not functional for this release.
TEST SET SYNCH OUT
Not functional for this release.
TIMEBASE ADJUST
This is the timebase adjust cover. Removing this screw allows access for timebase adjustment.
TRIG IN
This BNC connector provides the capability for you to trigger measurements or instruments from an external source. Setting the Trigger Source setting to External for measurements or instruments which support this feature causes the measurement or instrument to trigger when a positive-going TTL compatible pulse is applied to this connector. Currently, the only measurement or instrument which supports this feature is the Spectrum Monitor.
TRIG OUT
This BNC connector allows you to synchronize the test set to other equipment and is configured by setting Frame Trigger Parameters.
VGA OUT
This DB-15 connector allows you to simultaneously route the test set's display to another monitor.
10 MHZ REF IN
This BNC connector accepts an external 10 MHz timebase signal. The nominal input impedance is 50 ohm. This version of test set can only accept a 10 MHz timebase signal.
10 MHZ REF OUT
This BNC connector provides a 10 MHz timebase signal to external test equipment. The accuracy of this signal is determined by the timebase used. The nominal output impedance is 50 ohm with a typical level of 0.5 V rms.
