Last updated: December 3, 2008
GSM TA |
This command sets/queries the Expected Burst parameter in the active (that is the selected) format. This parameter is used for measurement synchronization when the test set's operating mode is set to one of the Test Mode Operating Modes . The command to set the operating mode is CALL:OPERating:MODE (If it is not set, the test set may not synchronize to the input signal's midamble). Also, the BCC (Base Station Colour Code) parameter, which sets the downlink TSC, should be set prior to the Operating Mode. The command to set this parameter is CALL[:CELL]:BCCode . |
|
GPRS TA | ||
GSM/GPRS LA | ||
GSM |
Range: RACH | TSC0 | TSC1 | TSC2 | TSC3 | TSC4 | TSC5 | TSC6 | TSC7 |
|
GPRS |
Range: RACH | TSC0 | TSC1 | TSC2 | TSC3 | TSC4 | TSC5 | TSC6 | TSC7 |
|
GSM |
Range: RACH | TSC0 | TSC1 | TSC2 | TSC3 | TSC4 | TSC5 | TSC6 | TSC7 |
|
GPRS |
Range:RACH | TSC0 | TSC1 | TSC2 | TSC3 | TSC4 | TSC5 | TSC6 | TSC7 |
|
The *RST value of this command depends on the format that is currently active. For example, if the GSM format is currently active, the *RST value for this command is the same value as the equivalent command containing the :GSM format identifier. |
||
Requirements |
GSM/GPRS/ EGPRS TA |
|
GSM/GPRS/ EGPRS LA | ||
OUTPUT 714;"CALL:BURSt:TYPE TSC2" ! Sets the test set to expect Training Sequence Code 2 in the midamble burst. |