Agilent Technologies Home Page 8960 Series 10 Wireless Communications Test Set
- +
Home | Product Web Site | Contact Us
+
- -
+ -
8960 GSM/GPRS/EGPRS Online User's Guide
E1968A, E6701F, E6704A
Search this guide for     
search tips


Feedback
Did the information on this web page help answer your question or solve a problem?

Yes
No
Did not apply

Please provide additional comments about this page.
(Optional, 255 character max)


Email address (optional):

Privacy Notice: We will not sell or give away your email address to any third party.

 

How Do I Gain Access to All the EGPRS Multislot Configurations?

Last updated: December 2, 2008

This section is only applicable when the test set's operating mode is Active Cell (EGPRS). If you wish to gain access to all the EGPRS Multislot Configurations while the test set's operating mode is EGPRS BCH+PDTCH see Gain Access to All EGPRS Data Rate Configurations .

Some multislot configurations are not selectable by default when the system type is EGPRS. You can gain access to these configurations by setting the value of the EGPRS Data Rate Configuration parameter to All. However, the performance of the unsupported data rate configurations is not guaranteed.

   
CAUTION
You may need to upgrade the hardware in your test set before installing the application firmware described here. If you install application firmware on a test set with incompatible hardware, the following may occur:

  • Your test set may lock up.
  • The application may not run.
  • Some features in the application may not be accessible, or may not perform to specifications.

Please review the hardware requirement information at

http://www.agilent.com/find/8960upgrades

to determine if a hardware upgrade is required for your testing needs.

   

Procedure

  1. Press the CALL SETUP key.
  2. Press Operating Mode ( F1 ) and select Active Cell (EGPRS) .
  3. Select PDTCH Parameters ( F9 ) from the Call Parms menu.
  4. Press the More softkey on the right side of the front panel display to access the PDTCH Parms ( 2 of 3 ) menu.
  5. Press Multislot Config ( F7 ). Notice that some of the selections are grayed out.
  6. Press the More softkey on the right side of the front panel display to access the PDTCH Parms ( 1 of 3 ) menu.
  7. Select Modulation Coding Scheme ( F11 ) from the PDTCH Parms menu. The Modulation Coding Scheme popup menu appears.
  8. Scroll to EGPRS Data Rate Configurations and select All from the pop-up menu. The following warning message appears:
    Warning: Not all EGPRS data rate configurations are supported
  9. Press Close Menu ( F6 ).
  10. Press the More softkey on the right side of the front panel display to access the PDTCH Parms ( 2 of 3 ) menu.
  11. Press Multislot Config ( F7 ). Notice that all the selections accessible now.

Top of pagetop of page     

+
Privacy Statement | Terms of Use | Webmaster  +  © Agilent 2000-2008
+