How do I change the EGPRS Demodulation Type to Normal?
Last updated: December 2, 2008
This section is only applicable to the EGPRS test application.
This procedure assumes that the BCH parameter for Cell Band is set up correctly for your mobile station and that the appropriate RF IN/OUT Amplitude Offsets have been set to offset loss between the mobile station and the test set. You can only change the EGPRS demodulation type while in Active Cell (EGPRS).
-
Press the
CALL SETUP
key.
-
Press
Operating Mode
(
F1
) and select
Active Cell (EGPRS)
.
-
Press
Data conn Type
(
F2
) and select
ETSI Type A
.
-
Press the
More
softkey on the left side of the front panel display to access the
Control
(
2 of 2
) menu.
-
Select
Protocol Control
(
F4
).
-
Select
Layer 1
(
F1
).
-
Select
EGPRS Demod
(
F2
). The
EGPRS Demod
popup menu appears.
-
Select
Normal
.
|
top
of page