How Do I Configure the AUDIO OUT Port?

Last updated: December 2, 2008

A. Select a signal to output at the AUDIO OUT port.

Press the SYSTEM CONFIG key.
Press the More key on the left side of the display for additional system parameters.
Press the Audio Out Port ( F1 ) key.
Turn the knob to highlight a selection and then press the knob.

NOTE

To facilitate the change of signal selection for output to the front-panel AUDIO OUT port while performing different tasks, you can also access the Audio Out Port settings from several other menus: Audio Generator control menu, Swept Audio Setup menu, Call Parms menu (2 of 3) in AVC Test operating mode, and Call Parms menu (2 of 3) in Active Cell operating mode with AMPS system selected. Changing the selection on one menu will be applied to all other menus.

NOTE

Selection of FM Demod signal routed to the front-panel AUDIO OUT port is useful only in AMPS system. There will be no guaranteed performance for the signal present at the Audio Out Port when FM Demod is selected for output.

B. Set FM Demod signal.

When FM Demod signal is selected for output to the front-panel AUDIO OUT port, a bandpass filter, expander circuit, and de-emphasis circuit can be individually inserted or bypassed in the FM Demod signal path.

Press the SYSTEM CONFIG key.
Press the More key.
Press the FM Demod Setup ( F2 ) key.
Turn the knob to highlight a selection and then press the knob.
Enter a value or selection and press the knob.
Press the Close Menu ( F6 ) key.

NOTE

If the FM Demod Setup settings are changed while the Audio Out Port selection is not FM Demod (see A. Select a signal to output at the AUDIO OUT port. ), the values will be stored for use when Audio Out Port is set to FM Demod.