How Do I Configure Test Signals in CW Operating Mode?

Last updated: December 2, 2008

1. Press the CALL SETUP key.
2. Press the Operating Mode ( F1 ) key and set the operating mode to CW .
3. Press the Cell Power ( F7 ) key and set the signal output power level to meet your testing needs.
4. Press the RF Gen Freq ( F8 ) key and set the signal output center frequency to meet your testing needs.
5. Press the Receiver Control ( F12 ) key and manually set the test set's receiver control parameters (such as Expected CW Power, Measurement Frequency, and Uplink Frequency) to the desired values.