How Do I Make GPRS Measurements on a Mobile?
Last updated: December 4, 2008
This section is
not
applicable to GSM.
A. Establish a data connection.
-
Press the blue
SHIFT
key.
-
Press the green
Preset
key.
-
Connect the mobile.
-
Turn the mobile on and wait for
Attached
in the
Active Cell:
field.
For mobiles that don't perform GPRS attach automatically, set the mobile to data mode.
-
Press the
Start Data Connection
(
F3
) key and watch for the
Active Cell:
field changing to
Transferring
.
If you have problems establishing a data connection using the default BLER Data Connection Type (that is,
Data Conn Type
(
F4
) is set to
BLER
), you may want to change the setting of the
BLER FCS (Frame Check Sequence)
or the
Block Poll Rate
. To change these settings, press the
More
key to access the
Control
menu (
2 of 2
), then press the
Protocol Control
(
F4
) key. Block Poll Rate is available under the RLC/MAC (
F1
) key and BLER FCS is available under the LLC (
F2
) key. Select a parameter and change its setting.
B. Select measurements.
-
Press the
Measurement selection
key.
-
Highlight a measurement and press the knob.
-
Repeat steps 1 and 2 to add measurements.
|
top
of page