How Do I Perform Calling Party Number Verification?
Last updated: December 3, 2008
This section is only applicable to the lab application.
Procedure
-
Press the
Call Setup
key.
-
Verify that the
Operating Mode
(
F1
) is set to
Active Cell(GSM)
or
Active Cell(GPRS)
or
Active Cell(EGPRS)
and the
Data Conn Type
(
F2
) is set to
Auto
for this example.
-
Press the
More
key in the left side twice to move to the Control Menu 3 of 3.
-
Press
Calling Party Number Parms
(
F5
). The Calling Party Number Parameters menu is displayed. See
Parameter Descriptions
for details.
-
Select
Calling Party Number Inclusion
.
-
Turn the knob and select Include from the drop down menu.
-
-
If required, select the
Calling Party Number
and enter a desired value.
-
Up to 20 characters from the set of 0123456789abc*# can be entered in the entry box. The digits of 0-9 are entered from the DATA ENTRY keys and the characters of "abc*#" are entered from the newly displayed softkeys on the right of the screen.
Enter the value in the Calling Party Number text entry
Once the entry box goes away, the
Calling Party Number
field can display up to 14 characters. If the length of the entered string is greater than 14 characters, only the first 11 characters followed by a "..." are displayed in the
Calling Party Number
field. Use the GPIB command (
CALL:CPNumber<[:SELected]>
) to query the whole string.
-
If required, select other parameters and set to the desired value. In this example, the default settings are used.
-
Press the Close Menu (
F6
).
-
(Optional) To capture a protocol log for further analysis, start a capture in the Wireless Protocol Advisor (WPA) software (see
Protocol Logging
) and then perform the following steps.
-
Press the Originate Call (
F3). The test set originates a call to the mobile station.
-
Observe the mobile station's screen. Verify that the mobile station receives and displays the calling party number. If the Calling Party Number is not displayed on the mobile station' screen, ensure that Presentation Indicator is set to "Allowed".
-
Stop WPA.
-
If you start a WPA capture in step 5, verify that the test set sends an SETUP message with the calling party number parameters. An example log file is shown as below.
|
top
of page