Manual Operation

Last updated: May 13, 2009

This page provides links to information on using the test set from the front panel including: Call Processing Operations (such as making a call, handovers), Call Processing Configuration (configuring the test set's base station emulator), Making Measurements (how to use the measurements in general, and also how to perform 3GPP TS 34.121 tests, see Performing Individual Measurements and 3GPP TS 51.010 Tests ), Data Channel , Test Set Configuration (such as amplitude offsets, GPIB and LAN ports), General Manual Operation (such as Help Mode, which provides context-sensitive GPIB command syntax assistance, and Save and Recall Registers, which provide a way to return to frequently used setups).

Call Processing Operations

How Do I Set Up a Call?
- Setting Up the Call Parameters
- Establishing a Mobile Terminated Call
- Establishing a Mobile Originated Call
How Do I End a Call?
How do I Make Rach Measurements?
How Do I Change the Payload Pattern Sent to the Mobile Station?
- Change the GSM Downlink Speech Payload
- Change the GPRS/EGPRS Payload Pattern
How Do I Set Up and Use the Frequency Hopping Feature?
How Do I Perform a Handover?
How Do I Perform an EGPRS Handover?
How Do I Access the Medium Access Control (MAC) Parameters? (GPRS/EGPRS LA Only)
How to view Measurement Reports (LA Only)
How to use the Adaptive Multi-Rate (AMR) and Wideband AMR (AMR-WB) Features (LA Only)
How to use Protocol Logging (LA Only)
How to use the Short Message Service Features (LA Only)
Enabling the HTTP Interface
How to use Timing Advance Control. (LA Only)
How do I test Incremental Redundancy? (EGPRS LA only)
How do I test MCS Switching? (EGPRS LA only)
How do I change the Downlink TBF Puncturing Scheme? (EGPRS LA only)
How Do I Use the Data Throughput Monitor? (LA Only)
How Do I Perform Calling Party Number Verification? (LA Only)
How Do I Set Up and Test Cell Selection and Transitions? (LA Only)
How Do I Set the TBF Parameters? (GPRS/EGPRS LA Only)
How Do I Set Up and Use the Dual Transfer Mode Feature? (LA Only)
How to access DUT PDP Setup (GPRS/EGPRS LA Only)
How to use the Digital Audio Interface Features (LA Only)
How Do I Use Real-Time Vocoder?
How Do I Set Up and Use the Configurable Timers?
How Do I use Mobile Calculated BER Test

Call Processing Configuration

Making Measurements

Data Channel

Test Set Configuration

How Do I Configure the Test Set for My Test System? (GPIB address, amplitude offsets, etc.)
How Do I Configure the AUDIO OUT Port?
How Do I Configure Test Signals in CW Operating Mode?
How Do I Make an External Device Connection?
How Do I Make a FM Broadcast test? How Do I Make a FM Broadcast test?