How Do I Use the 34.121 Preset Call Configurations?
Last updated: January 15, 2009
This section is only applicable to the lab application or feature-licensed test application.
-
Press the
CALL SETUP
key.
-
Set
Operating Mode
(
F1
) to
Cell Off
.
-
Select
34.121 Preset Call Configs
(
F11
).
-
Select the preset configuration with which you wish to start.
-
Select
Yes
when asked to "
Overwrite Current Parameters?
".
-
Set
Operating Mode
(
F1
) to
Active Cell
.
-
Set any other parameters needed to allow your UE to camp to the test set and establish an HSDPA or HSPA RB test mode connection.
-
Power on the UE and wait for it to register with the test set.
-
Originate an HSDPA or HSPA RB test mode connection.
-
Initiate the measurement(s) needed to perform the selected 34.121 test(s) and perform the test(s).
-
To move between 34.121 sub-tests while on a call, use the Transport Channel Reconfiguration to change the parameters that differ between the sub-tests. The presets configure the test set for 3GPP TS 34.121 Table C.10.1.4 sub-test 3 (HSDPA) or Table C.11.1.3 sub-test 1 (HSPA).
-
To move between the 34.121 preset call configurations while on a call, use the Transport Channel Reconfiguration to change the parameters that differ between the configurations. See
34.121 Preset Call Configurations
for more information.
|
top
of page