How Do I Change Receiver Control Parameters?
Last updated: January 15, 2009
In some instances you may want to control the test set's receiver settings manually rather than allowing the test set to automatically control them. This ability is referred to as manual receiver control (see
Receiver Control
).
Manual Receiver Control in Active Cell, Cell Off or FDD Test Operating Mode
-
Press the
CALL SETUP
key.
-
Press
Operating Mode
(
F1
) and select
Active Cell, or Cell Off, or FDD Test
.
-
Press the
More
key two times until
3 of 3
is displayed.
-
Press the
Receiver Control
(
F12
) key.
-
To manually set the receiver's expected power, highlight the
Power Control
field and select
Manual
, then enter a a desired value in the
Manual Power
field by using the knob or numeric keys.
-
To manually set the receiver's measurement downconverter frequency, highlight the
Measurement Frequency
field and enter a desired value to replace the
Auto
with the knob or numeric keys.
-
(In FDD Test mode only) To manually set the receiver's demodulation downconverter tune frequency, turn the knob to highlight the
Uplink Frequency
field and enter a desired value to replace the
Auto
with the knob or numeric keys.
Manual Receiver Control in CW Operating Mode
-
Press the
CALL SETUP
key.
-
Press
Operating Mode
(
F1
) and select
CW
.
-
Press the
Receiver Control
(
F12
) key.
-
To set the receiver's expected power, turn the knob to highlight the
Expected CW Power
field and press the knob, then enter a desired value by using the knob or numeric keys and press the knob.
-
To set the measurement downconverter's tune frequency, turn the knob to highlight the
Measurement Frequency
field and press the knob, then enter a desired value by using the knob or numeric keys and press the knob.
-
To set the demodulation downconverter's tune frequency, turn the knob to highlight the
Uplink Frequency
field and press the knob, then enter a desired value by using the knob or numeric keys and press the knob.
-
Press
Close Menu
(
F6
).
|
top
of page