SETup Subsystem

Last updated: May 26, 2009

Description

The SETup subsystem is used to configure the test set for each measurement. Typical settings include:

Multi-Measurement Count, how many measurements will be made each time a measurement is initiated.
Trigger Arm, determines if a measurement will make one measurement then return to idle (single), or automatically rearm on completion of a measurement and repeat the process (continuous).
Trigger Source, how a measurement is triggered.
Trigger Delay, controls the delay time between the trigger and the start of sampling.
Measurement Timeout, length of time before a measurement times out.

NOTE

Trigger arming for each measurement is controlled in the SETup subsystem. The choices are single or continuous. In most cases, it is a best practice (during remote operation) to use "single" measurement mode. This simplifies the tasks of starting concurrent measurements, using the INIT subsystem commands to determine which measurements are ready to be fetched, then using the FETCh subsystem to obtain results. The command "SETup:CONTinuous:OFF sets all measurements to "single" trigger mode.

Syntax Diagrams and Command Descriptions

SETup:CONTinuous

SETup:AFANalyzer (AF Analyzer measurements)

SETup:CFDTune (Fast Device Tune measurement) lab application or feature-licensed test application only

SETup:EVMQpsk (QPSK EVM measurement) lab application only

SETup:FSTability (Frequency Stability measurement)

SETup:HBLerror (HSDPA Block Error Ratio) lab application or feature-licensed test application only

SETup:HRCQuality (HSDPA Reporting of Channel Quality Indicator measurement) lab application only

SETup:SAUDio (Swept Audio measurement)

SETup:SMONitor (Spectrum Monitor measurements)

SETup:WACLeakage (Adjacent Channel Leakage measurements)

SETup:WBERror (Loopback Bit Error Ratio measurements)

SETup:WBLerror (Loopback Block Error Ratio measurement)

SETup:WCDomain (Code Domain measurement)

SETup:WCPower (Channel Power measurement)

SETup:WCTFormat (Change Of TFC) lab application only

SETup:WDPAnalysis (Dynamic Power Analysis measurement)

SETup:WEDPower (Extended Range Dynamic Power measurement)

SETup:WILPower (Inner Loop Power measurement)

SETup:WIQTuning (IQ Tuning measurement)

SETup:WOBWidth (Occupied Bandwidth measurement)

SETup:WOOPower (PRACH Transmit On/Off Power measurements

SETup:WOOSynch (Out-of-Synch Handling of Output Power) lab application only

SETup:WPDiscon (Phase Discontinuity measurement)

SETup:WPPAnalysis (PRACH Preamble Analysis measurement) lab application only

SETup:WSEMask (Spectrum Emission Mask measurement)

SETup:WTDPower (TX Dynamic Power measurement)

SETup:WTPower (Thermal Power measurement)

SETup:WWQuality (Waveform Quality measurement)