How Do I Configure and Enable (Start) Event Reporting?

A. Configure Event Parameters

1. Go to the Soft Handover Information Screen

2. Select SHO / Event Parameters ( F2 ).

3. Set event parameters as needed.

B. Enable Event Reporting

1. Go to the Soft Handover Information Screen
2. Set Event State ( F4 ) to On . The test set sends a Measurement Control message to the UE with the event parameter configuration specified in step A. Configure Event Parameters .
   

The UE reports events for cell 1 and cell 2 as they occur, as well as MS reported measurement results for each cell.

C. Change Event Parameters

1. A. Configure Event Parameters .
2. Select Send Event Config ( F5 if Event State is On ), to send a new Measurement Control message to the UE, specifying the changes to the event parameters.