How Do I Change Inter-RAT Configurations?

How Do I Change Inter-RAT Configurations?

Last updated: April 20, 2011

This section is only applicable to the lab application.

A. Select the Inter-RAT Config Info Menu.

  1. Press the CALL SETUP key.
  2. Press the left More key, go to Call Control 2 of 3 (in the Lab Application).
  3. Select Access Network Info ( F2 ), go to AN Info 2 of 2.
  4. Select Inter-RAT Config Info ( F1 ).

B. Set the Inter-RAT Parameters.

  1. Select Inter-RAT Config Parms ( F1 ) if you want to set the general parameters for Inter-RAT operations. Select E-UTRAN Neighbor Parameters ( F2 ) if you want to set parameters in OtherRATNeighborList Message that are not specific to a EARFCN. Select E-UTRAN Neighbor EARFCN Parms ( F3 ) if you want to set the EARFCN specific parameters.
  2. Turn the knob to highlight a parameter and then press the knob.
  3. Enter a value or selection and press the knob.
  4. Select Close Menu ( F6 ).

Related Topics

Inter-RAT Config Info