Stops all measurements that are active. You can also use the ABORt:<measurement mnemonic> commands to stop the active measurements individually. If the trigger arm is set to single, the measurements will go to the idle state. If the trigger arm is set to continuous, the measurements will re-arm and initiate again. See Measurement States . |
|
Requirements |
Test Application Revision: A.01.20 and above Test Application Revision: A.02.20 and above: Added CTDPower Lab Application Revision: A.01 and above: Added GAPPower Test Application Revision A.06 and above with the required feature license: added CFDTune Lab Application Revision: A.03 and above: Added CFDTune |
OUTPUT 714;"ABORt" !Aborts all active measurement in progress. |
This command stops the specified measurement if it is active:
You can also use the ABORt[:ALL] command to stop all measurements that are active. If the trigger arm is set to single, the measurements will go to the idle state. If the trigger arm is set to continuous the measurements will re-arm and initiate again. See Measurement States . |
|
Requirements |
Test Application Revision: A.01.20 and above Test Application Revision: A.02.20 and above: Added CTDPower Lab Application Revision: A.01 and above: Added GAPPower Test Application Revision A.06 and above with the required feature license: added CFDTune Lab Application Revision: A.03 and above: Added CFDTune |
OUTPUT 714;"ABORt:DOWQuality" !Aborts the waveform quality measurement |