This section is only applicable to the lab application.
You can use the Ping feature of the test set to:
Data Channel Info
(
F2
) key.
Data Channel Parameters
(
F1
) key.
Close Menu
) to close the Data Channel Parameters menu.
Return
), go back to Call Control 3 of 3 menus.
Ping
(
F3
) key.
Ping Setup
(
F1
) key and verify that
Device to Ping
is set to
DUT
. If required, set the
Ping Count
,
Timeout
, and
Packet Size
.
Connected
or
Dormant
. Otherwise, follow the procedure of
How Do I Make a Packet Data Connection?
to establish a packet data connection.
Start Ping
(
F3
) key. If the connection is good, the DUT will return packets to the test set and the packet transfer information is displayed on the test set's screen. A typical display is shown below.
Ping
(
F3
) key.
Ping Setup (
F1
)
.
Alternate Ping Address
to your desired target IP address (for example, a remote server running the data applications is connected to the same LAN with your test set).
Device to Ping
to
Alternate
.
Start Ping(
F3
)
. If the connection is good, then the device being pinged (such as the remote server) will return packets to the test set and the packet transfer information is displayed on the test set's screen