How Do I Assign Different Modulation Coding Schemes / Puncturing Schemes to Each Downlink of a Multislot Burst?

Assign MCS / PS to Each Downlink of a Multislot Burst

1. Press CALL SETUP
2. Press Operating Mode ( F1 )
3. Select EGPRS BCH+PDTCH from the Operating Mode popup menu.
4. Press PDTCH Parameters ( F9 )
5. Press More on the bottom right of the screen so that 2 of 3 is displayed.
6. Press Multislot Config Setup ( F11 )
7. Choose a multislot configuration from the Multislot Config menu. The figure below shows a portion of the Multislot Config menu. The gray entries are unsupported. Note: If you set the EGPRS Data Rate Configuration to All , the entries in the Multislot Config menu change, see Gain Access to All EGPRS Data Rate Configurations .
   
8. Press More on the bottom right of the screen so that 2 of 3 is displayed.
9. Press MCS / PS ( F7 )
10. Select a Modulation Coding Scheme / Puncturing Scheme (MCS / PS) for each downlink burst of the multislot configuration you selected in step seven.

Gain Access to All EGPRS Data Rate Configurations

1. Follow steps 1-4 of Assign MCS / PS to Each Downlink of a Multislot Burst .
2. Press MCS / PS ( F7 )
3. Highlight the Data Rate Configuration parameter in the MCS / PS menu.
4. Choose which configuration you want from the Configs Available menu. Notice if you choose All, when you push the knob the test set displays a warning that states, " Warning; Not all EGPRS data rate configurations are supported ". Press CANCEL to make this warning disappear.
5. Follow steps 5-10 of Assign MCS / PS to Each Downlink of a Multislot Burst to assign an MCS/PS for each downlink of a multislot burst or press Close Menu ( F6 ).

Related Topics

Modulation Coding Scheme/Puncturing Scheme (MCS/PS)

EGPRS Data Rate Configurations

Supported Multislot Classes