Last updated: December 2, 2008
The mobile station operating parameters are configured using the following call processing subsystem commands.
For a complete list of GPIB commands in the call processing subsystem, refer to CALL Subsystem .
Defines an additional offset value used to increase the Max CCHannel value for DCS band only |
|
Mobile DTX State | CALL:MS:DTX[:STATe] |
Mobile station TX Level | CALL:MS:TXLevel[:SELected] |
Timing Advance | CALL:MS:TADVance[:SELected] |
CALL:SETup:(PDTCH|PDTChannel):MS:TXLevel[:SELected]:BURSt<[1]|2|3|4|5> |
|
Defines an additional offset value used to increase the Max CCHannel value for DCS band only |
|
CALL:MS:PATTach[:STATe] | |
CALL:(PDTCH|PDTChannel):MS:TXLevel[:SELected]:BURSt<[1]|2|3|4|5> |
|
CALL:(PDTCH|PDTChannel):MS:TXLevel[:SELected]:BURSt<[1]|2|3|4|5> |
|
CALL:(PDTCH|PDTChannel):MS:TXLevel[:SELected]:BURSt<[1]|2|3|4|5> |
|
Uplink Burst TX Level for selected PDTCH band | CALL:(PDTCH|PDTChannel):MS:TXLevel[:SELected]:BURSt<[1]|2|3|4|5> |
CALL:(PDTCH|PDTChannel):MS:TXLevel[:SELected]:BURSt<[1]|2|3|4|5> |
|
There are a number of parameters for the broadcast channel (see Configuring the Broadcast Channel (BCH) ) and the traffic channel (see Configuring the Traffic Channel (TCH) Parameters ) that can be configured, however the test set's default parameters should allow a properly functioning mobile station to successfully camp on the cell and make a call under most circumstances.
When Operating Mode = Active Cell, if a call is connected, changes to these parameters, including a change to the value of the parameter's current setting, causes signaling on the downlink to automatically initiate the change. No separate command is necessary to initiate the change. If a call is not connected, changes to the parameter are stored for when the next call is established
For details on the parameters you can use to configure the PDTCH, see Configuring the Packet Data Traffic Channel (PDTCH) .