Configuring the Test Set and Starting a Data Connection for GPRS Measurements

Test Set Configuration

Setup parameters for this measurement are assumed to be set to their default (Full preset) values unless otherwise stated. This procedure also assumes that the BCH parameter for band is set up correctly for your mobile station and that the appropriate RF IN/OUT Amplitude Offsets have been set to offset loss between the mobile station and the test set.

1. Press the CALL SETUP key.
2. Press Operating Mode ( F1 ) and select Active Cell (GPRS) .
3. Press the Data Conn Type ( F2 ) key, and select ETSI Type A. (See Connection Types for other connection types that can be used with EGPRS measurements.)
4. Select PDTCH Parameters ( F9 ) from the Call Parms menu.
5. Select Coding Scheme ( F11 ) from the PDTCH Parms menu. The Coding Scheme popup menu appears.
6. Select one of the coding schemes.
7. Press the Close Menu ( F6 ) key.

How Do I Start a Data Connection?

1. Connect the mobile.

2. Turn the mobile on and wait for Attached in the Active Cell: field.

3. Press the Start Data Connection ( F3 ) key and watch for the Active Cell: field changing to Transferring .