E-TFCI Recording Information

Last updated: November 11, 2010

This section is only applicable to the lab application or feature-licensed test application.

The Recorded E-TFCI Information screen displays the E-TFCI Recording State , Current E-TFCI Boost , Recorded E-TFCI Values and Number of E-TFCI Results Recorded . These results are set to their default values if you select Measurement Reset , when the Operating Mode changes, when a new HSPA connection is established in Active Cell Operating Mode , or when Channel Type changes to/from 12.2k RMC + HSPA while in FDD Test Operating Mode . The results are also set to their default values if you select Clear UE Info when the test set is not recording.

• E-TFCI Recording State

  This result indicates whether the test set is currently recording a sequence of E-TFCI values from the UE. Possible states include Recording and Idle.

  GPIB command: CALL:STATus:ETFCi:RECord[:STATe]?

• Current E-TFCI Boost

  GPIB command: CALL:STATus:ETFCi:BOOSt?

• Recorded E-TFCI Values

  This result returns the sequence of E-TFCI values recorded when the Start Recording E-TFCI Values action was initiated.

  GPIB command: CALL:STATus:ETFCi:RECord:ALL?

• Number of E-TFCI Results Recorded

  The number of E-TFCI results recorded is displayed at the bottom of the Recorded E-TFCI Values window (as shown circled above). When recording is active, this result is updated every 0.5 s. When recording is idle, this result indicates the number of E-TFCIs in the Recorded E-TFCI Values result.

  GPIB command: CALL:STATus:ETFCi:RECord:COUNt?