This section is applicable to the lab application and to a test application with the required feature license.
You can send MMS messages in different scenarios:
The tests can be implemented by following the general steps and some specific configurations below:
STEP A: Set Up the Test System
STEP B: Install the Software to Simulate MMSC/WAP Gateway
STEP C: Configure the Test Set
You should set up the test system consist of PC, test set(s), mobile station(s) according to different Scenarios for MMS Message Transmission .
An MMSC emulated by an external software (such as NowSMS provided by Now Wireless Limited.) is required for MMS tests. You can download and get its functionality and configuration manual on the web:
Press the Call Setup key.
Operating Mode
(
F1
) is set to
Active Cell
and the
System Type
(
F2
) is set to
IS-2000
for this example.
Data Config
(
F11
) to set radio configuration is
(Fwd3, Rvs3)
or above.
Press the
FCH Service Option Setup
(
F12
) to set service option for the selected radio configuration (such (Fwd3, Rvs3))is
SO33(+F-SCH)/SO33
. If you select
SO33(+F-SCH)
you could change the
F-SCH Data Rate
.
SO33(+F-SCH)
you could change the
F-SCH Data Rate
.
4 of 5
of the
Call Control
menu is displayed.
Data Channel Information
(
F2
), then press the
Data Channel Parameters
(
F1
) to set
F-SCH Data Rate
to 76.8kbps.Setup HTTP SMS State:
4 of 5
of the
Call Control
menu is displayed.
Short Message Service
(
F5
), then go to
SMS Control
menu
2 of 2
.
HTTP Setup
(
F4
), then set
HTTP SMS Input State
to
on
.
HTTP Setup
(
F4
), then set
HTTP SMS Output State
to
on
.
HTTP SMS Input State
of the test set 1 to
on
and the
HTTP SMS Output State
of the test set 2 to
on
.Setup the Mobile Station:
For 1. Mobile-Terminated MMS Messages .